Teach you Make the LED Tube, Now Do It Yourself
Look those instructions about the LED tube
1. First you buy the baton tube, then cut into 1 foot, you can remove the cover.
2. The tube was nailed to the wood, and the other side needs to hang in a garage or other suitable places rafters.
3. Tube gently to evenly sprayed white paint. In order to obtain uniform coating in Gatling, please carefully use your fingers.
4. Plug the cut and stripped interconnect cable plugs into the plugs at either end of the light strip.
5. Cut the wire of the interconnect cable in half between the plugs located at either end. Strip the ends of the wire you just cut.
6. Solder the wires together at one end, then cover the expose part wire with electrical tape. Coil up the wire. Use a hot glue gun to glue this wire under an end cap.
7. Insert the light strip into the tube and put on the end cap, sealing it in place with a hot glue gun. Be careful not to melt the tube with the heat.
8. Drill a hole into the end of the remaining end cap with the ?-inch drill bit. Cut a length of extension cord to the length that you desire.
9. At both ends strip the end of an extension cord and strip the wires inside. The positive and negative wires from one end through the hole and solder them to the leads on the interconnect wire (except for the ground wire which is left free).
10. Tie a small overhand knot into the cord above the hole and glue the knot and extra wire to the end cap. Glue the end cap in place.
11. There will come out of the extension cord At the end of the other side. Then strip wires leading to a cigarette lighter plug.
12. Strip wires leading to a cigarette lighter plug. In any hidden with exposed electrical wire coating with liquid glue. Buy a universal AC to DC converter that will allow you to plug in the cigarette lighter plug into the wall.